Broken Garage Door Springs Replacement

When you have broken torsion springs with your garage door, you can either call an experienced garage door expert like Atlanta garage door spring repair service or you can handle it yourself. The metal springs are long and heavy devices that are used to raise and lower the garage door. If you have malfunctioning or broken springs that need to be taken care of here are the actions which you can perform to get the task finished. Following important steps will help you to make sure that the job will be done completely.

The most important step which you need to remember is to make sure that you have turned off the power to the opener so that you will not get electrocuted while performing repairs. Furthermore, disconnect the power cord of the opener from a garage door. The rule is practical for both the newer electrical model of garage door and for the older version of a garage door. For extra safety precaution, you will have to turn off the circuit breaker or remove the fuse to turn off the power supply.

Look closely at the broken garage door springs to make sure that the new one will be the same. Examine and compare both to make sure that they are the same size, type, and dimension. While holding a spring, avoid grabbing them by the other spring. Be careful and don’t touch the winding cones of the new springs. Use a permanent marker or any other type of writing instrument to highlight the torsion shaft ends. It is important to step because it helps you to make sure that your garage door will maintain its balance when you have finished the job of spring replacement.  

Wind the functional spring off and unfasten the bolts and screws by securing torsion cones and spring mounting brackets together, after that removes the bolts immediately. Once you have done this process in the project of broken garage door spring replacement. It is time to replace the old springs along with hanging hardware. After completing this step, it is the right time to wind up the required spring. Once you have done this process, you need to check the balance or alignment to make sure that it will open smoothly. In order to eliminate friction, you will have to apply some type of lubricant. 

Once you have tested the garage door to confirm that it is properly balanced and all the hardware is tightened and secured in place, it is time to reconnect the garage door opener again. You might be advised that playing with a garage door is not good but you have to test the garage door.

Open and close the garage door a few times to make sure that it is functioning smoothly. Thus, it is easy to replace the broken garage door springs on your own but you will have to do it carefully because it can be a dangerous task if not handled properly. You could lose your limbs, hands, fingers, legs, or even life. So it is always wise to hire a professional garage door services to handle this dangerous job.